Herunterladen Inhalt Inhalt Diese Seite drucken

Sony ICF-SW1000T Bedienungsanleitung Seite 11

Fm stereo/sw/mw/lw pll synthesized receiver stereo cassette-corder
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

5
REC
Tips
• Adjusting VOLUME and
TONE does not affect the
sound to be recorded.
• Speaker output is
monaural when recording.
To enjoy FM stereo
reception, plug the stereo
headphones.
• Recording stops
automatically when
RADIO POWER ON/OFF
is pressed to turn off the
radio.
Notes
• Use Type I (normal)
cassettes only for
recording. Playback may
be distorted or a
previously recorded
segment may not be
erased completely when a
CrO
or metal cassette is
2
used.
• Recording with weak
batteries generates
unnecessary noise and
produces unsatisfactory
recordings. In this case,
replace the batteries with
new ones.
• Operate REC
approximately 2 seconds
prior to the point you wish
to begin recording. If not,
the leading segment may
not be recorded.
• Switching the recording
side is not possible when
œ is pressed during
recording.
• The buttons for the radio
are operational while
recording. To prevent
accidental operations, use
the hold function (see
page 30).
Press the red button in the center
and slide REC.
To stop recording
Press p.
To record the side facing the unit (reverse side)
Insert the cassette with the side you wish to record
facing the unit (reverse side). Press œ while pressing
p to display "ª REV".
Recording stops on the side facing the unit regardless
of whether one side or both sides is selected.
To record an FM stereo broadcast
Set ST • MONO to ST or MONO to select stereo or
monaural recording as necessary.
To improve AM reception for recording
When recording an AM broadcast, the reception may
contain noise interferences that were not present prior
to recording. In this case, set ISS on the bottom of the
unit to the position (1, 2 or 3) in which noise
interferences are minimal to obtain optimum
reception for recording.
To protect your important recorded cassettes
Break off the cassette tab of side A or B to prevent
accidental recording of your important cassettes. If
you wish to use the cassette for recording again, cover
the opening of the broken tab with adhesive tape.
"†" flashes when recording is attempted on a
cassette with a broken tab. A cassette with a broken
tab cannot be recorded.
TUNE
REC
After a few seconds, the
frequency is displayed.
Side A
Tab
Adhesive tape
Basic Operations
PAGE
1
2
3
FWD
11
EN

Quicklinks ausblenden:

Werbung

Inhaltsverzeichnis
loading

Diese Anleitung auch für:

Icf-sw1000ts

Inhaltsverzeichnis