Connection - Xoro HRS 8500 Bedienungsanleitung

Connecting to the dish and TV
General information
•
Assure that the device is switched off and unplugged.
•
Read the manual of your TV and attend to the safety instructions.
•
Please establish an accurate connection.
•
Please check the video output settings.
The schematic picture shows the connection of the HRS 8500 to the satellite dish and the TV.
Installation Guide
1. Connect a SCART or HDMI cable to the DVB-S receiver.
2. Connect the aerial cable to the aerial input (LNB IN) of the HRS 8500. Screw the plug to the
input.
3. Connect the SCART or HDMI cable to the TV set.
3. Connect the power cable and the plug to the wall outlet.
4. Switch on your DVB-S receiver and the TV set.
5. Choose the correct input (SCART or HDMI) at your TV.
Note:
By using the loop through connector you can connect for example a second DVB-S Receiver.
14

Connection

HRS 8500