PeakTech 2795 Bedienungsanleitung Seite 25

* Measurement Mode Switch: Release the "MEAS" button
and press the "MODE" button before the instrument auto
power off(released the "MEAS" button this instrument will
auto power off in 15 sec).There are two group of
measurement. You can press the "MODE" button once to
change from RPM, rpm, HZ,....to the next sequentially. Press
the "MODE" button and hold for approx.3 sec to leap to the
next group. .Then you can press the "MODE" button once to
change from REV, M, In....to the next sequentially. Selected
the mode of you need, depress the "MEAS" start measures.
* RPM: Non-Contact revolutions per minute measurements.
* rpm: Contact revolutions per minute measurements.
* HZ: Non-Contact /Contact frequency measurements.
* M/M: Contact Meter per minute measurements.
-25-