Technical Data; Noise/Vibration Information; Declaration Of Conformity - Bosch GCM 8 S Professional Originalbetriebsanleitung

OBJ_BUCH-198-003.book Page 37 Thursday, April 10, 2008 2:56 PM
57 Allen screw (size 3 mm) for standard bevel
angle 0° (vertical)
58 Allen screw (size 3 mm) for standard bevel
angle 45° (vertical)
59 Recessed grips
60 Caps for carbon brushes
61 Carbon brushes
*The accessories illustrated or described are not in-
cluded as standard delivery.

Technical Data

Sliding Mitre Saw
Article number
Rated power input
Rated voltage
Frequency
No-load speed
Laser type
Laser class
Weight according to
EPTA-Procedure
01/2003
Protection class
Maximum workpiece dimensions, see page 42.
Starting cycles generate brief voltage drops. Interfer-
ence with other equipment/machines may occur in
case of unfavourable mains system conditions. Mal-
functions are not to be expected for system impedanc-
es below 0,24 ohm.
The values given are valid for nominal voltages [U] of
230/240 V. For lower voltage and models for specific
countries, these values can vary.
Please observe the article number on the type plate of
your machine. The trade names of the individual ma-
chines may vary.
Dimension of suitable saw blades
Saw blade diameter
Blade thickness
Saw blade mounting
hole
Bosch Power Tools

Noise/Vibration Information

Measured values determined according to
EN 61029.
Typically the A-weighted noise levels of the
product are: Sound pressure level 98 dB(A);
Sound power level 111 dB(A). Uncertainty
K =3 dB.
Wear hearing protection!
The hand-arm acceleration is typically below
2.5 m/s

Declaration of Conformity

GCM 8 S
We declare under our sole responsibility that
Professional
the product described under "Technical Data" is
3 601 L16 0..
in conformity with the following standards or
W 1400
standardization documents: EN 61029,
EN 60825-1 according to the provisions of the
V 230
directives 2004/108/EC, 98/37/EC (until Dec.
Hz 50/60
28, 2009), 2006/42/EG (from Dec. 29, 2009 on).
rpm 5000
Technical file at:
Robert Bosch GmbH, Dept. PT/ESC,
650 nm, < 1mW
D-70745 Leinfelden-Echterdingen
2
Dr. Egbert Schneider
kg 15
Senior Vice President
Engineering
/ II
11.04.2008, Robert Bosch GmbH, Power Tools Division
D-70745 Leinfelden-Echterdingen
mm 210–216
mm 1.5–2.8
mm 30
2
.
Dr. Eckerhard Strötgen
Head of Product
Certification
1 619 P03 475 | (10/4/08)
English | 37