Delivery Scope - Bosch GTA 2600 Professional Originalbetriebsanleitung

OBJ_BUCH-843-003.book Page 16 Friday, May 7, 2010 12:39 PM
16 | English
Assembly

Delivery Scope

Please also observe the represen-
tation of the delivery scope at the
beginning of the operating instruc-
tions.
Before assembling the saw stand, check if all
parts listed below are provided:
No. Designation
Saw stand GTA 2600
6 Attachment set
8 Locking knob of the
attachment set 6
1 Workpiece support
5 Length stop
Fastening kit
consisting of:
– Carriage bolt
10 M8 x 26
11 M6 x 46
12 M8 x 44
13 – Washer
14 – Lock washer
15 – Nut locking device
16 – Nut
17 – Assembly-sliding plate
18 – Assembly-sliding plate with
slot
4 – Locking knob of the length
stop
Additionally required tools (not in delivery
scope):
– Phillips screwdriver
– Adjustable spanner
1 609 929 W87 | (7.5.10)
Assembling the Saw Stand
– Carefully remove all parts included in the de-
livery from their packaging.
– Remove all packaging material.
Setting Up the Saw Stand (see figures A1 – A2)
– Lay the saw stand upside down on the floor
(legs facing upward).
– Push the locking pin 19 in and tilt the leg up-
ward until the locking pin can be heard to en-
gage.
Quantity
– Repeat this workstep with the other three
1
legs.
– Turn around the saw stand to the working
2
position.
2
– Ensure that the saw stand is stable and that
all locking pins have engaged.
2
The saw stand is easily aligned with the height-
2
adjustable leg 9.
– Loosen lock nut 20 and screw the leg in or
out until the saw stand is aligned level and all
four legs face against the floor.
2
2
Mounting the Length Stop and Workpiece Sup-
4
port (see figures B1–B2)
4
– Screw the length stop 5 to the workpiece
4
support 1 with carriage bolt 11 and locking
2
knob 4.
4
– Insert the workpiece support into the table
2
extension 2.
2
– Tighten the locking knob 7 to lock the work-
piece support.
2
– Repeat the worksteps with the second work-
piece support.
Bosch Power Tools