Installation And Commissioning; Safety Instructions - bürkert S020 Bedienungsanleitung

Installationandcommissioning
7. inSTAllATion And
commiSSioning
7.1.

Safety instructions

danger
risk of injury due to high pressure in the installation.
• Stop the circulation of fluid, cut off the pressure and drain the
pipe before loosening the process connections.
risk of injury due to high fluid temperatures.
• Use safety gloves to handle the fitting.
• Stop the circulation of fluid and drain the pipe before loosening
the process connections.
risk of injury due to the nature of the fluid.
• Respect the prevailing regulations on accident prevention and safety
relating to the use of hazardous products.
Warning
risk of injury due to non-conforming installation.
• Fluidic installation can only be carried out by qualified and autho-
rised personnel with the appropriate tools.
• Observe the installation instructions for the measuring device
inserted into the fitting.
risk of injury due to an uncontrolled restart.
• Ensure that the restart of the installation is controlled after any
interventions on it.
Type S020
Warning
risk of injury if the fluid pressure / temperature dependency
is not respected.
• Take into account the fluid pressure / temperature dependency
according to the materials from which the fitting is made (see
Fig. 3) and to the measuring device used (see the relevant user
manual).
• Comply with the Pressure Directive 97/23/EC.
Warning
danger due to non-conforming commissioning.
Non-conforming commissioning may lead to injuries and damage
the fitting and its surroundings.
• Before commissioning, make sure that the staff in charge
have read and fully understood the contents of the Operating
Instructions.
• In particular, observe the safety recommendations and intended
use.
• The installation must only be commissioned by suitably trained
staff.
English
21