Philips GC7600 Bedienungsanleitung Seite 12

ENGLIsh
12
Problem
The 'ANTI-
CALC cartridge
replacement' light
keeps flashing.
The appliance
produces a loud
pumping sound.
The appliance has
switched off.
The iron leaves a
shine or an imprint
on the garment.
The ironing board
cover becomes
wet or water
droplets come out
of the soleplate.
There is too much
steam coming out
of the iron.
Possible cause
You have to replace the
ANTI-CALC cartridge.
You have just installed a new
ANTI-CALC cartridge.
The water tank is empty.
The ANTI-CALC cartridge
is not in place.
The safety auto-off function
is activated automatically
when the steam generator
has not been used for more
than 5 minutes.
The surface to be ironed
was uneven, for instance
because you were ironing
over a seam or a fold in the
garment.
Steam has condensed on
the ironing board cover
after a long ironing session.
You may have an ironing
board that is not designed
to cope with the high steam
rate of the steam generator.
The default setting of the
iron is the OptimalTemp
setting. In this setting the
iron provides a high steam
output.
This iron has been approved by The Woolmark Company Pty Ltd for
the ironing of wool only products provided that the garments are ironed
according to the instructions on the garment label and those issued by the
manufacturer of this iron. R1101. In United Kingdom, Eire, HongKong and
India, the Woolmark trademark is a Certification trademark.
Solution
Replace the ANTI-CALC cartridge (see chapter
'IMPORTANT: Replacing the ANTI-CALC cartridge').
You can also use demineralised water or descaled
water from the IronCare. In that case, you need to
leave the exhausted cartridge in the compartment.
Continue to press the steam trigger until the
pumping sound stops and steam comes out of the
soleplate.
Refill the water tank with water and press the
steam trigger until the pumping sound stops and
steam comes out of the soleplate.
Place the ANTI-CALC cartridge (see chapter
'Before first use - Placing the ANTI-CALC
cartridge').
Press the on/off button to reactivate the steam
generator.
Perfect Care is safe on all garments. The shine or
imprint is not permanent and will disappear when
you wash the garment. Avoid ironing over seams or
folds or you can place a cotton cloth over the area
to be ironed to avoid imprints.
Replace the ironing board cover if the foam material
has worn out. You can also add an extra layer of felt
material under the ironing board cover to prevent
condensation on the ironing board.
Put an extra layer of felt material under the ironing
board cover to prevent condensation on the ironing
board.
Activate the ECO mode to iron with a lower
steam output. See section 'Energy saving' in this user
manual.