Intended Use; Operating Instructions - Truma Therme Gebrauchsanweisung

Intended use

The water in the Therme is heated by the hot air of the heating
system or by a 230 Volt electric heater element.
8

Operating instructions

Always observe operating instructions prior to starting!
The vehicle owner is responsible for the correct operation of
the appliance.
Never operate the Therme electrically without water
contents! Don't forget to turn the appliance off when
the caravan is not being used! Drain in event of frost!
There shall be no guarantee claims for damage caused
by frost!
The installer or vehicle owner must affix the yellow sticker
with the warning information, which is enclosed with the ap-
pliance, to a place in the vehicle where it is clearly visible to
all users (e.g. on the wardrobe door)! Ask Truma to send you a
sticker, if necessary.
Repair work is only to be carried out by an expert!
The Therme is designed for pressure-free operation. In
order to enable the pressure, which builds up during the
heating up procedure, to escape, there is to be no non-return
valve installed in the cold water supply (1) between Therme
and submergible pump.
When connecting to a central water supply (city mains) or
when using stronger pumps, a pressure reduction valve must
always be installed to prevent that pressures above 1.2 bar
develop in the Therme. In addition, a safety/drain valve (acces-
sory, part no. 70141-10) must be installed into the cold water
supply line (1).
Materials in the device which come into contact with water
are suitable for use with drinking water (see manufacturer
declaration: www.truma.com – Manufacturer Declaration).