Storage; Possible Faults - ATIKA BH 1400 N Originalbetriebsanleitung

Storage

Pull out mains plug.
Store unused equipment in a dry, locked place out of the
reach of children.
In case of extended storage (e.g. during winter) ensure that
the device is protected against frost and corrosion.
Before a longer period of storage carry out the following to
extend the machine's service life and ensure an easy operat-
ing:
− Thoroughly clean the device.
− Treat metal parts after each use against corrosion using
an environmentally friendly biologically degradable spray
oil.
Before each fault elimination:
− Switch off device.
−
wait until the hoeing tools are stationary
− Pull out mains plug.
After each fault clearance, put into operation and recheck all security installations.
Fault code
Trimmer does not operate.
Trimmer does not operate.
The device operates with
interruptions
Unusual sounds
Unusual vibrations
Unsatisfactory result
20

Possible faults

Possible cause
No power
Extension cable defective.
Main plug, motor or switch defect
Protective motor switch has tripped
Extension cable defective.
Internal fault
ON/OFF switch defective
Hoeing tools blocked
Loose screws, nuts or other fasteners
Lack of lubricant
Lubricant emerges
Hoeing tools damaged or dull
Excessive working depth
Dull hoeing tools
Insufficient working depth
To store the device space-saving it is possible to fold
down the upper handle hoop (1). For this, loosen the
thumb nut (21) until you can fold down the handle hoop.
Corrective action
Check power supply, power outlet, fuse protec-
tion
Check extension cable, exchange defect cable
immediately
Have main plug, motor or switch checked by an
approved electrician or replaced by original
spare parts
1. Excessive working depth
depth
2. Hoeing tools blocked
Allow the motor to cool down approx. 15 minutes
before continuing to work
Check extension cable, exchange defect cable
immediately
Contact the customer service
Contact the customer service
Remove the blockage
Tighten all parts; contact customer service if the
noises continue to occur.
Refill lubricant.
Contact the customer service
Contact the customer service
Reduce the working depth.
Contact the customer service
Increase the working depth.
reduce the working
remove the blockage