Connection/Cabling - Carson Dragster 6S Betriebsanleitung

c. Connection/Cabling
Connect the ESC, motor, receiver,
battery and servo according to the
following diagram.
GB
Positive (+) and negative (-) wires of the ESC are
connected with the battery pack. A, B and C are
connected with the motor wires. The control cable
of the ESC (wires in black, red and white colour) is
connected with the throttle channel of the receiver
(usually CH2).
Black power
wire (battery
negative)
Switch
Input TH channel
Receiver
20 CARSON Brushless Speed Controller Dragster 6S
Red power wire
(battery
positive)
Input
ST-wire
The A, B, C wires of the ESC can be connected with
the motor wires freely (without any order). If the
motor runs in the opposite direction, please swap
any two wire connections.
Battery
Orange
wire
Yellow wire
Blue wire
Steering servo
Brushless motor