Maintenance Intervals; Winter - Maintenance; Dismounting / Mounting The Pump - T.I.P. WPS 2000 R Gebrauchsanweisung

7.1.

Maintenance intervals

The time intervals for the required maintenance task (complete cleaning) to a great
extent are based on the level of pond water contamination. Select the time intervals
for cleaning accordingly. If, when performing maintenance tasks, you determine
that there are defects or wear, replace the parts in question (see ordering spare
parts).
7.2.

Winter - maintenance

 Protect your pump from freezing!
 If there is danger of freezing, take the pump out of your garden pond.
 Completely clean the pump as specified in the instructions.
 Store the pump over winter in a frost-free location.

8. Dismounting / mounting the pump

1. Comply with the safety measures. Disconnect the pump from the mains
supply!
2. Press the sides of the front cover (9) and pull it off of the pump (Fig. 1).
3. Pull the filter sponge out of the filter cover.
4. Turn the inflow cover (6) anticlockwise approx. 20° (Fig. 2).
5. Pull the inflow cover (6) out of the pump.
6. Pull the rotor with rotor axle and bearing (4, 3 and 2) out of the pump.
Note: For technical reasons, the impeller and the magnet can be turned against
each other by a certain angle.
7. Mount the pump as follows:
7.1. Insert the rear bearing (4) and the rotor axle (2). Make sure that they
are perfectly seated in the bearing. Then insert the rotor (3) into the
pump and attach the front bearing to the rotor axle.
7.2. Insert the inflow cover (6) and turn clockwise to the stop.
7.3. Reattach the front cover (9) to the pump body.
For trouble-free operation, repeat this procedure depending on the degree of
fouling and duration of operation.
6
15