Items Supplied; Unpacking; Before Using For The First Time - Silvercrest 109237 Bedienungsanleitung

WARNING! Risk of material
damage
Hard, pointed objects (such as metal
spoons) can damage the non-stick coat-
ing of the baking plate 1. Only use the
included kitchen utensils, or utensils
made of wood or heat-resistant
Never place the device on hot surfaces
(e.g. hob plates) or near heat sources or
open fire.
Only use the original accessories.
The device is fitted with non-slip silicon
feet. Because furniture can be coated
with a wide variety of varnishes and
plastics, and treated with various care
products, the possibility cannot be ex-
cluded that some of these substances
have ingredients that may attack and
soften the silicon feet. If necessary,
place a non-slip mat under the device.
Do not use any astringent or abrasive
cleaning agents.
DANGER for birds
Birds breathe faster, distribute the air
differently in their bodies and are signif-
icantly smaller than humans. For this
reason, it may be dangerous for birds to
inhale even the smallest smoke quanti-
ties, which develop while this device is
running. When using this device, birds
should be relocated into a different
room.

4. Items supplied

1 Crêpe Maker
1 batter spreader 8
1 crêpe flipper 7
1 operating instructions

Unpacking

1. Remove all parts from the packaging.
2. Check that all parts are present and in-
tact.
6
GB
5. Before using for the
first time
FIRE HAZARD! Before turning the
device on, place it on a level, sta-
ble, dry, heat-resistant surface.
plastic.
DANGER! Risk of injury
through burning! The appli-
ance's baking plate 1 gets very hot
during operation. Only touch the
control elements of the device dur-
ing operation.
NOTE: you may notice an odour when us-
ing for the first time. This is a result of the
manufacturing process and is not a defect
with the device. Ensure adequate ventila-
tion.
• Clean the appliance before using
it for the first time (see "Clean-
ing" on page 8)!
1. Unwind the mains cable 6 completely.
2. Place the baking plate 1 on the bottom
section 2.
3. Insert the power supply plug into a suit-
able mains socket. The red indicator 3
comes on to show that the appliance is
connected to the power supply.
4. Turn the temperature control to
"MAX". As soon as operating temper-
ature has been reached, the green indi-
cator 5 comes on. During operation,
the green indicator 5 (and thus the
heater) will continually turn on and off.
This serves to maintain as constant a
temperature as possible.
5. Leave the appliance switched on for
around 10 – 15 minutes.
6. Remove the power supply plug and al-
low the appliance to cool down.
7. Clean the appliance again.