Checklist Before Svc Calls - Samsung SR8980 Benutzerhandbuch

troubleshooting

CHECKLIST BEFORE SVC CALLS

Symptom
Vacuum cleaning
robot does not
operate at all before
cleaning.
Vacuum cleaning
robot stopped
operating while
cleaning.
The suction power is
weak while cleaning.
Checklist
• Is the dust bin assembled?
• Is the Power Switch turned on?
• Is cleaning mode
panel turned on?
• Is the battery level fl ashing only
one level and is 'Lo' displayed in
the display panel?
• Vacuum cleaning robot will not
operate when the battery in the
remote control is depleted.
• Is the battery level fl ashing only
one level and is 'Lo' displayed in
the display panel?
• Has the vacuum cleaning robot
become hooked on wires on the
fl oor?
• Is the vacuum cleaning robot stuck
to the fl oor where there is a height
difference?
- The driving wheel is lifted.
• Is there a thin towel (cloth)
wrapped around the driving wheel?
• Is the vacuum cleaning robot stuck
on the doorsill?
• Check whether the dust bin is full
of dust.
• Check whether the suction inlet is
clogged by foreign substances.
• Check whether the fi lter is clogged.
• Install the dust bin.
• Turn on the Power Switch.
• Press the
in the display
off, press and hold the
down for 3 seconds or longer.)
• Lift up the vacuum cleaning robot,
and manually dock the vacuum
cleaning robot onto the charger to
charge it.
• Replace the batteries in the remote
control. (AAA type)
• Lift up the vacuum cleaning robot,
manually dock the robot onto the
charger to charge it.
• Turn off the Power Switch and
remove the wires.
• Turn off the Power Switch and
move the cleaning vacuum
cleaning robot to another place to
clean.
• Turn off the Power Switch and
remove the thin towel.
• Turn off the Power Switch and
move the vacuum cleaning robot
to another place to clean.
• Stop the vacuum cleaning robot
and empty the dust bin.
• Turn off the Power Switch and
remove the foreign substances on
the suction inlet.
• Clean the fi lter well.
Measure to Take
button. (To turn it
button
troubleshooting _47