Installation; Before The Installation - Electrolux EQG4120BOG Benutzerinformation

Problem
The flame extinguishes im-
mediately after ignition.
The flame ring is uneven.
7.2 If you cannot find a
solution...
If you cannot find a solution to the
problem yourself, contact your dealer or
an Authorised Service Centre. Give the
data from the rating plate. Make sure, you

8. INSTALLATION

WARNING!
Refer to Safety chapters.

8.1 Before the installation

Before you install the hob, write down the
information bellow from the rating plate.
The rating plate is on the bottom of the
hob.
Model .......................................
PNC .........................................
Serial number ...........................
8.2 Gas Connection
WARNING!
The following instructions
about installation, connection
and maintenance must be
carried out by qualified
personnel in compliance with
standards and local
regulations in force.
Make sure that during the installation the
appliance is not connected to electrical
supply. Disconnect the mains plug or
deactivate the fuses. Disconnect the
mains gas supply.
Possible cause
Thermocouple is not heated
up sufficiently.
Burner crown is blocked
with food residues.
operated the hob correctly. If not the
servicing by a service technician or dealer
will not be free of charge, also during the
warranty period. The instructions about
the Service Centre and conditions of
guarantee are in the guarantee booklet.
Make sure that there is a stop tap
assembles between the gas supply of
house and the appliance.
The settings for this appliance are located
on the rating plate. The present settings
for the type of gas and gas pressure are
on a sticker.
Choose fixed connections or use a flexible
pipe in stainless steel in compliance with
the regulation in force. If you use flexible
metallic pipes, be careful they do not
come in touch with mobile parts or they
are not squeezed. Also be careful when
the hob is put together with an oven.
This appliance is not connected to an
exhaust gas outlet. It must be connected
in accordance with the installation
conditions that apply. Pay special
attention to correct airflow.
ENGLISH
Remedy
After lightning the flame,
keep the knob pushed for
equal or less than 10 sec-
onds.
Make sure that the injector
is not blocked and the
burner crown is clean.
11