7
Special Functions
Adjusting the lamp-head's low-battery warning LEDs
Use this program to adjust the onset of the low-battery warning.
1.
Press and hold the button for 7 seconds, until 4
release the button.
2.
The threshold can be selected as shown below.
red
Backlight:
Blue
green
6.0 V
5.6 V
5.2 V
6.2 V
5.8 V
5.3 V
6.4 V
6.0 V
5.4 V
Default setting
6.6 V
6.2 V
5.5 V
6.8 V
6.4 V
5.6 V
Recover factory settings:
1.
Press and hold the button for 8 seconds, until 5
release the button.
2.
Disconnect the battery, and all factory settings will be restored.
4 4
Wilma
green
LEDs
light up.
red LEDs
turn on.
Product care and storage
Plug contacts:
Normally the plug contacts are maintenance free. However, if you use your Wilma light in humid, salt-
air, environments, it's advisable to apply a thin layer of
often to prevent oxidation.
Do NOT use terminal grease or contact spray.
Transport:
Important: Always keep the battery separate from the Wilma light,
amount of power used by the electronics will discharge the battery, and the lamp may switch on
accidently.
Important! Moreover, the consequent uncontrolled heat buildup could cause a fire or
melt the adjacent plastic material. Could cause fire or
Storage:
During lengthy periods of non-use, fully charge the battery and store it in a cool, dry place, basement
or the like. The battery can be kept plugged into the charger if desired.
Opening the light housing:
Open the light housing's front screw-on cover. Grasp the rear section of the lamp with one hand while
rotating the front section of the cover to the left (counterclockwise) with the other hand. Once you
have removed the cover, you will see the 4-array lens. Do not touch it.
Closing the lamp housing:
Check to ensure that the O-ring on the rear section of the housing is correctly positioned.
The housing will only be waterproof if its O-ring is intact. After completing this inspection, carefully
screw down the housing cover.
Important note: if the thread runs smooth, the cap is in the right
position. Otherwise please stop and screw back the cover and try again, otherwise you might
damage the thread.
Lupine Dutch Grease
to the contacts every so
because otherwise the small
death!
Wilma
7
45