Dell PowerEdge 6850 serie Handbuch Seite 22

Figure 1-12. Removing and Installing the Peripheral Interposer Board
1 retention tab
Installing a Peripheral Interposer Board
1 Connect the backplane power cable to the front of the interposer board. See Figure 1-11.
2 Install the peripheral interposer board:
Carefully lower the interposer board into the system, being careful to avoid damaging components
a
on the face of the board. See Figure 1-12.
Align the installation alignment slot on the bottom of the interposer board with the alignment pin
b
on the bottom of the chassis.
Slide the retention slots on the interposer board over the retention hooks on the chassis.
c
Slide the board downward until the blue retention tab snaps into place.
d
20
SAS Information Update
1
2 installation alignment slot
2
3
3 peripheral interposer board