Exemple De La Console De L'assistant Dell Easy Setup - Dell Networking N1500 Serie Handbuch Zum Einstieg

Exemple de la console de l'Assistant Dell Easy Setup

L 'exemple suivant contient la séquence d'invites et de réponses associée avec
un exemple de session en exécution de Assistant Dell Easy Setup avec les
valeurs indiquées ci-dessus.
Au démarrage du commutateur (après le POST), la boîte de dialogue
suivante s'affiche :
Unit 1 - Waiting to select management unit)>
Applying Global configuration, please wait...
Welcome to Dell Easy Setup Wizard
The Setup Wizard guides you through the initial switch
configuration, and gets you up and running as quickly
as possible. You can skip the setup wizard, and enter
CLI mode to manually configure the switch. You must
respond to the next question to run the setup wizard
within 60 seconds, otherwise the system will continue
with normal operation using the default system
configuration. Note: You can exit the setup wizard at
any point by entering [ctrl+z].
Would you like to run the setup wizard (you must
answer this question within 60 seconds)? [Y/N] y
Step 1:
The system is not set up for SNMP management by
default. To manage the switch using SNMP (required for
Dell Network Manager) you can
. Set up the initial SNMP version 2 account now.
. Return later and set up other SNMP accounts. (For
more information on setting up an SNMP version 1 or
3 account, see the user documentation).
Would you like to set up the SNMP management interface
now? [Y/N] y
To set up the SNMP management account you must specify
the management system IP address and the "community
string" or password that the particular management
system uses to access the switch. The wizard
Guide de mise en route
63