Pannelling The Door - AEG Electrolux ARCTIS AU66050-6E Gebrauchsanweisung

7. Remove the plugs (G) and fit them on
the opposite side.
8. Insert the pin of the door bearing (1)
into the left hand cavity and screw
the bearing firmly into place with the
screws (K).
9. Move the separate part (L) of the ven-
tilation grille from the left to the right
and fit it on the opposite side.
10. Unscrew the handle and refit it on the
opposite side.
plastic plugs

Pannelling the door

1. Take off the door frame section opposite to
the door handle.
2. Loosen, without removing them, all remaining
screws securing the door frame.
3. Slide in the decor panel from the frameless
side, then fasten again the frame to the door
including the previously removed frame sec-
tion.
Note:
The overall dimensions of the decor panel must be 1 to 2 mm less than
those of the door, with a maximum thickness of 4 mm.
The holes that are not used are to be masked with the
removed.
G
L
AEG60/1
Installation
33