Installation; Unpacking And Levelling; Electric And Water Connections - Indesit WITL 126 Bedienungsanleitung

Installation


Keep this instruction manual in a safe place for
GB
future reference. Should the appliance be sold,
transferred or moved, make sure the instruction
manual accompanies the washing machine to inform
the new owner as to its operation and features.

Read these instructions carefully: they contain vital
information on installation, use and safety.

Unpacking and levelling

Unpacking
4. Seal the gaps using the plastic plugs provided.
5. Keep all the parts: you will need them again if the
washing machine needs to be moved to another
location.
Warning: should the screws be re-used, make sure
you fasten the shorter ones at the top.

Packaging materials are not children's toys.
Levelling
front feet (see figure); the angle of inclination,
measured according to the worktop, must not
exceed 2°.
14
1. Unpack the washing
machine.
2. Check whether the
washing machine has
been damaged during
transport. If this is the
case, do not install it
and contact your
retailer.
3. Remove the four
protective screws and
the rubber washer with
the respective spacer,
situated on the rear of
the appliance (see
figure).
1. Install the washing
machine on a flat sturdy
floor, without resting it
up against walls,
furniture cabinets or
other.
2. If the floor is not
perfectly level, compen-
sate for any unevenness
by tightening or
loosening the adjustable
Levelling your appliance correctly will provide it with
stability and avoid any vibrations, noise and shifting during
operation. If it is placed on a fitted or loose carpet, adjust
the feet in such a way as to allow enough room for
ventilation beneath the washing machine.
Putting your appliance in place and moving it.
Once the appliance is in the required position, put the
lever back in place. The washing machine is now firmly
in place (see figure).

Electric and water connections

Connecting the water inlet hose
A
3. Make sure there are no kinks or bends in the hose.

The water pressure at the tap must be within the
values indicated in the Technical details table
(on the next page).

If the water inlet hose is not long enough, contact
a specialist store or an authorised serviceman.

Never use hoses that have already been used.
If your washing
machine is equipped
with a special set of
retractable wheels you
can easy move it. To
lower the wheels and
thus move the
appliance effortlessly,
just pull the lever,
situated on the left-hand
side beneath the base.
1. Insert seal A into the
end of the inlet hose
and screw the latter
onto a cold water tap
with a 3/4 gas
threaded mouth (see
figure).
Before making the
connection, allow the
water to run freely
until it is perfectly
clear.
2. Connect the other
end of the water inlet
hose to the washing
machine,
screwing it onto the
appliance's cold water
inlet, situated on the top
right-hand side on the
rear of the appliance
(see figure).