Personalisations; Setting The Temperature; Setting The Spin Speed; Functions - Indesit WITL 125 Bedlenungsanleitung

Personalisations

C

Setting the temperature

Turn the TEMPERATURE knob to set the wash temperature (see Programme table on page 6).
The temperature can be lowered, or even set to a cold wash ( ).

Setting the spin speed

Turn the SPIN SPEED knob to set the spin speed for the programme selected.
The maximum spin speeds for each programme are as follows:
Programmes Maximum spin speed
Cottone 1200 rpm
Synthetics 800 rpm
Wool 800 rpm
Silk no
The spin speed can be lowered, or the spin cycle can be excluded altogether by selecting symbol
The washing machine will automatically prevent you from selecting a spin speed higher than the maximum speed for each
programme.
Note. To avoid excessive vibrations, before every spin cycle the machine distributes the load in a uniform manner by conti-
nuously rotating the drum at a speed which is slightly faster than the normal washing speed.
When, despite repeated attempts, the load is still not evenly distributed, the machine spins at a lower speed than the set
frequency.
If the load is excessively unbalanced, the machine attempts to distribute it instead of spinning.
The balancing attempts may extend the total duration of the cycle, up to a maximum of 10 minutes.

Functions

To enable a function:
1. press the button corresponding to the desired function, according to the table below;
2. the function is enabled when the corresponding button is illuminated.
Note: The rapid flashing of the button indicates that the corresponding function cannot be selected for the programme set.
Option Effect
Delays the start of the
wash by up to 9 hours.
Delay Timer
Bleaching cycle de-
signed to remove the
toughest stains.
Bleaching
This option reduces
the amount of creasing
on fabrics, making
them easier to iron.
Easy iron
Increases the efficiency
of the rinse.
Extra Rinse
Comments
Pess the button repeatedly until the LED corresponding to the
desired delay is turned on. The fifth time the button is pressed, the
function will be disabled.
N.B.: Once you have pressed the Start/Reset button, the delay
can only be decreased if you wish to modify it.
Please remember to pour the bleach into extra compartment 4
(see page 8).
This option is incompatible with the EASY IRON option.
If you set this option, programmes 4, 5, 7 will be suspended, lea-
ving the laundry to soak (Anti-crease) and icon
- to conclude the cycle, press the START/RESET button;
- to run the draining cycle alone, set the knob to the relative
symbol and press the START/RESET button.
This option is incompatible with the BLEACHING option.
Recommended when the appliance has a full load or with large
quantities of detergent.
.
Enabled
with pro-
grammes:
All
2, 3, 4, 5,
Rinse
cycle.
3, 4, 5, 7,
will flash: 8, 9, 10
and Rinse
cycle.
1, 2, 3, 4, 5,
6, 7, 8, 9,
10, 12, 13
and Rinse
cycle.
GB
7