Use Of Dishwasher Salt - Küppersbusch IGVS6808.0 Benutzerinformation

Manual adjustment
The appliance is set at the factory at po-
sition 2.
1. Open the door.
2. Remove the lower basket.
3. Turn the water hardness dial to position
1 or 2 (refer to the chart).
4. Install the lower basket.

Use of dishwasher salt

Caution! Only use dishwashers salt.
Types of salt that are not applicable for
dishwashers cause damage to the water
softener.
Caution! Grains of salt and salty water
on the bottom of the appliance can
cause corrosion. Fill the appliance with
salt before you start a washing
programme to prevent corrosion.
Do these steps to fill the salt container:
1. Turn the cap anticlockwise to open the
salt container.
2. Fill the salt container with 1 litre of water
(only the first operation).
3. Use the funnel to fill the salt container with
salt.
5. Close the door.
Electronic adjustment
The dishwasher is factory set at lev-
el 5.
1. Go into the menu options.
2. Go to 'Water hardness'.
3. Use the option button to set the level of
the water softener. Refer to the chart for
the right level to set.
4. Press the OK/Start button to confirm.
4. Remove the salt around the opening of
the salt container.
5. Turn the cap clockwise to close the salt
container.
It is normal that water overflows from the salt
container when you fill it with salt.
The display shows a message when the salt
container is empty.
After you fill the salt container, the message
can continue to stay on for some hours. This
does not have an unwanted effect on the op-
eration of the appliance.
The message, when the salt container is
empty, will not show while a washing
programme operates.
27