Roborock F25 ACE Bedienungsanleitung Seite 8

Maintenance
Part
Frequency
Clean tank 2-4 weeks
Adaptive
As needed
drive wheels
Notes:
• The frequency of replacement may vary with the
actual situation. If abnormal wear occurs, replace the
parts immediately.
• The filter and roller fibers have been treated with silver
ion antimicrobial agent to resist bacterial odors.
• The vacuum cleaner must be powered off or stopped
running, and the charging dock unplugged before you
clean or maintain them.
Product Maintenance
If this product is left unused for a prolonged
period of time, fully charge it, unplug it,
and store it in a cool and dry place. Do not
place it in humid locations or direct sunlight.
Charge it at least once every 3 months to
avoid battery overdischarge.
Vacuum Cleaner
Wipe and clean the vacuum cleaner with a
soft, dry cloth. Before cleaning, remove the
vacuum cleaner from the charging dock and
power it off.
Dirty Tank and Filter
D1
D1-1—Uninstall the dirty tank, pull out the
tank cover, and remove the filter on
the tank cover. Use the provided
maintenance brush to clean the
Replacement
debris on the filter. If the filter is very
Frequency
dirty, rinse it with cold water and
N/A
shake off the remaining water.
D1-2—Dry all the parts thoroughly before
N/A
reinstalling them back in place.
Notes:
• Allow at least 24 hours for the filter to dry thoroughly
before reinstalling it.
• Do not touch the filter surface with hands, brushes, or
sharp objects to avoid damaging it.
Clean Tank and Roller
D2
D2-1—Grip the clean tank handle, press the
release button, and gently pull the
clean tank upwards at a slight angle
to uninstall the tank.
D2-2—Rinse the tank bottom with clean water.
D2-3—Grab the roller release tab and pull
the roller out along the cleaner head.
Use the provided maintenance brush
to remove the dirt on the roller, then
rinse it with clean water.
D2-4—When you need to replace the roller,
pull the roller cap out of the roller by
grabbing the whole cap. Then, install
the roller cap to a new roller.
Notes:
• Use the maintenance brush carefully to avoid injury.
• When you detach the roller cap, do not pull it by its
handle.
• To prevent potential damage, keep the roller cap
attached while cleaning the roller.
D2-5—Reinstall the roller and clean tank.
D3
Clean the adaptive drive wheels regularly.
D4
1. Power off the vacuum cleaner and place
2. Clean the roller slot and dirty water
3. Reinstall the dirty tank, clean tank, and
Note:
D5
Unplug the charging dock and use a
soft, dry cloth to clean its surface and the
charging contacts.
Note:
07
Adaptive Drive Wheels
Cleaner Head and Dirty
Water Pathway
it in a stable position, then remove the
dirty tank, clean tank, and roller.
pathway with the provided maintenance
brush.
roller.
Do not rinse the cleaner head directly with water.
Charging Dock
Do not rinse the charging dock directly with water.