Herunterladen Diese Seite drucken

Bruder Mannesmann Werkzeuge 22320 Gebrauchsanweisung Seite 14

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 4
Detergent will only be added to the cleaning water in low-pressure mode as set on the
nozzle.
Fan
nozzle
Detergent can only be mixed into the cleaning water in low-pressure
Switch the operating mode to high or low pressure by sliding the nozzle sheath (22) to
the back
or front.
For your high-pressure cleaner to mix detergent to the cleaning water, slide the nozzle
sheath (22) towards the front as far as it will go.
When you squeeze the trigger (19) on the gun, detergent will automatically be added to
the cleaning water.
Slide the nozzle sheath (22) back towards the gun as far as it will go to set the operat-
ing mode to high pressure.
Some detergent may briefly escape after switching from low to high pressure if the
detergent reservoir is full.
Cleaninq
with your hiqh-pressure
If necessary, first clean the object from coarse soil in high-pressure mode.
Spray the detergent onto the surface and allow it to soak in. Do not leave it to dry.
Spray off the loosened soil in high-pressure mode.
Fan
Nozzle
By twistingthe nozzlecasing(22)the flow can be adjustedbetweenjet (23)and spray (24)
via the fan nozzle.
Rotor
Nozzle
The rotor nozzle (14) creates a rotating jet of water. This can be used to achieve rapid
cleaning of large areas of the ground or walls.
First follow the instructions above under the heading "Before Using Equipment"
Mount the rotor nozzle (14) onto the spray lance (12) as described earlier.
When the trigger (19) is pressed a rotating jet is produced.
Using the trigger gun in a sweeping motion algae and moss, for example, can be
removed
from
exterior
Larqe-Surface
Cleaner
The large-surface cleaner (17) facilitates the efficient cleaning of patios, paths and similar
large areas and, at the same time, offers the user optimal protection from splashes. The
high-pressure nozzles in the cleaning head are rotated by the water pressure. The casing
and the surrounding cleaning brushes create virtually no splashing.
Place the surface cleaner coupling (17) onto the spray lance (12) until you hear it click
into place. According to the requirements the extension (16) can be mounted between
gun and spray lance.
—VVERKZEUGE
cleaner
surfaces.
GB
-14
mode.

Werbung

loading