Werbung
Verfügbare Sprachen
Verfügbare Sprachen
7. If necessary, remove the protective cap from the valve of the
object that is to be pumped up and quickly plug the com-
pressed air tube or the adapter onto / into the valve.
After it has been connected, the display measured pres-
sure (6) is shown on the display. Depending on the mode
and measured pressure, the indicator light (3) also lights up:
yellow < 30 psi
green 30 – 50 psi 2 – 3 bar 2 – 3 bar 6 – 16 psi
blue
red
8. Briefly press the button
Once the target pressure that has been set is reached, the
compressor stops automatically.
•
To deactivate the compressor prematurely, briefly press the
button
9. Quickly release the compressed air tube or adapter from the
valve. CAUTION: The connectors could be hot!
10. Reattach the protective cap to the valve if necessary.
11. To switch off the display, hold down the button
approx. 3 seconds.
12. Unscrew the adapter from the compressed air tube.
L
If no button is pressed for approx. 3 minutes,
the display automatically switches off.
Using the flashlight (2)
•
Switching on: Briefly press the
○ Press once: constant light
○ Press twice: flashing light
•
Switching off: Briefly press the
36
< 2 bar
–
the measured pressure is higher than the maximum
value that is pre-set in the selected mode
again.
< 2 bar
–
–
. The compressor starts to work.
button.
button once or twice.
< 4 psi
–
–
–
for
Werbung
