Werbung
4. Cymbals Assembly
8
Open the Hi-Hat Stand Base legs until the base plate is on the floor and tighten the wing nut. Unfold the
pedal and attach it to the base plate using the nut and bolt. Fit one Hi-Hat Cymbal between the two felts on
the clutch which comes attached to the pull rod, tighten the bottom nut.
Insert the Hi-Hat Stand Top Section into the Hi-Hat Stand Base, screw the pull rod into the thread in the
base of the stand. Add one Hi-Hat Cymbal on top of the felt, followed by the other with the clutch attached.
Adjust, leaving a gap so that the two cymbals clash together, tighten the wing nut.
Assemble Crash Cymbal Stand like the other stands, placing the Crash Cymbal between the two felts then
tighten the wing nut. You can adjust to the desired angle using the wing nut to secure it.
5. Drum Throne Assembly
Open the Throne Base to its maximum width and insert the Throne Centre Pole, tighten both wing nuts.
Throne height can be adjusted to suit the player by moving the wing nut to another hole in the pole. Finally
add the Throne Cushion and tighten the wing nut.
Werbung
