StreamLight TLR-7 HL-X sub Bedienungsanleitung Seite 6

cessful. Repeat the procedure above to change back to the high-lumen operation mode. When programming
is successful after holding the 10th tap, the light will brighten.
Note: Use a fully charged SL-B9
enabled when the TLR is powered with the SL-B9
at 500 lumens for up to 1.5 hours.
LASER SIGHT ZEROING
For a laser mounted below or to the side of the bore, there is only one distance where the bullet path will
coincide with the laser sight line. This point is the "zero range." Laser adjustment and the muzzle velocity of
the bullet determine where this point occurs. The user must decide how high above or below the sight line
the bullet can be allowed to strike and adjust the sight accordingly. At distances less than the zero range the
bullet will be above the sight line. Beyond the zero range the bullet will be below the sight line. If mounted
to the side, the bullet will also deviate to the side of the laser line, as well as up and down. In practice, a TLR
on a handgun can be adjusted to keep the bullet strike within about 2" high and 2" low out to about 100 feet.
There are two adjustment screws located on the left side of the flashlight body. The windage adjustment is
located closest to the bottom of the flashlight. Turn the set screw clockwise to move the laser to the left (POI
right). Turn the set screw counterclockwise to move the laser to the right (POI left). The elevation adjustment
is located higher up on the flashlight body angled downward. With the TLR pointed down range a clockwise
turn of the adjustment screw will move the laser up (POI down). A counterclockwise turn on the adjustment
screw will move the laser down (POI up). Move the laser dot in the direction that the shots are hitting the
target (example: If the bullets are striking low and right, move the laser dot down and right to coincide with
the bullet strike).
NOTE: When making large adjustments, there may be an interaction that causes the laser to move diagonally
or bind. It may become necessary to rotate the opposing adjustment screw counterclockwise to allow the
laser cartridge to move to the desired position.
MAINTENANCE
The TLR rail clamp tension bolt requires an application of high-quality gun oil to keep it rust free. Use a soft
cloth and mild detergent to clean the glass LED lens and keep it free of dirt and grime.
Note: Always avoid aggressive cleaning solutions as they may damage the TLR. If you shoot ammunition
with an exposed lead base on the bullets, the lens and face cap may become coated with lead. This may be
removed from the lens by rubbing with fine steel wool. It is extremely difficult to remove the lead coating from
the face cap. Wrap the face cap with electrical tape to avoid lead coating.
PRODUCT USE
Streamlight flashlights are intended for use as high intensity, heavy duty, and portable light sources. Use of
Streamlight flashlights for any purpose other than as light sources is specifically discouraged by the manufac-
turer. Streamlight specifically disclaims liability for other than recommended use.
Be sure to use only genuine Streamlight replacement parts to ensure product safety. Substitu-
NOTICE
tion may invalidate the product approval. Do not try to repair the unit yourself. Send to a
qualified service facility or return it to the factory.
Streamlight Limited Lifetime Warranty
Streamlight warrants this product to be free of defects for a lifetime of use except for batteries and bulbs,
abuse and normal wear. We will repair, replace or refund the purchase price of this product should we
determine it to be defective. This limited lifetime warranty also excludes rechargeable batteries, chargers,
switches and electronics which have a 2 year warranty with proof of purchase. THIS IS THE ONLY WAR-
RANTY, EXPRESSED OR IMPLIED, INCLUDING ANY WARRANTY OF MERCHANTABILITY OR FITNESS
FOR A PARTICULAR PURPOSE. INCIDENTAL, CONSEQUENTIAL OR SPECIAL DAMAGES ARE EXPRESSLY
DISCLAIMED EXCEPT WHERE SUCH LIMITATION IS PROHIBITED BY LAW. You may have other specific
legal rights which vary by jurisdiction.
Go to streamlight.com/support for a complete copy of the warranty. To register your product, go to
streamlight.com (Online Product Registration). Retain your receipt or any proof of purchase.
SERVICE OPTIONS
The TLR-7 HL-X sub / TLR-8
®
For service options, go to streamlight.com/support/service and complete the Online Service
Request for factory service or to find the location of an authorized Streamlight repair center near you.
Or contact:
Customer Service
© Streamlight, Inc.
30 Eagleville Road
Suite 100
Eagleville, PA 19403-3996, USA
Phone: (800) 523-7488 Toll-Free / +1 (610) 631-0600
Fax: (800) 220-7007 / +1 (610) 631-0712
Email: cs@streamlight.com
or fresh CR123A when changing operating modes. These modes are only
®
Elevation Adjustments
(angled downward)
Windage Adjustments
HL-X sub series contains few or no user-serviceable parts.
®
battery. If using a CR123A battery, the TLR will operate
®