Auto Disable; Auto-Disable Reason; Auto-Disable; Auto-Disable Timer - Hirschmann RM CLI HiOS-2S RSPS Referenzhandbuch

Auto Disable

4 Auto Disable
4.1

auto-disable

Configure the Auto Disable condition settings.
4.1.1

auto-disable reason

Enables/disables port Recovery by reason on this device.

Mode: Global Config Mode

Privilege Level: Operator

Format: auto-disable reason <P-1>
Parameter Value
link-flap
P-1
crc-error
duplex-mismatch
bpdu-rate
port-security
no auto-disable reason

Disable the option

Mode: Global Config Mode

Privilege Level: Operator

Format: no auto-disable reason
4.2 auto-disable
Configure the Auto Disable condition settings.
4.2.1

auto-disable timer

Timer value in seconds after a deactivated port is activated again. Possible
values are: 30-4294967295. A value of 0 disables the timer.

Mode: Interface Range Mode

Privilege Level: Operator

Format: auto-disable timer <P-1>
RM CLI HiOS-2S RSPS
Release 3.0 01/2014
Meaning
Enable/disable link-flap
Enable/disable crc-error
Enable/disable duplex-mismatch
Enable/disable bpdu-rate
Enable/disable MAC based port security
4.1 auto-disable
91