Ermenrich Reel GL60 Bedienungsanleitung Seite 7

Continuous measurement
In single distance measurement mode, press (3) for 3 seconds. The device will keep taking measurements one after another.
MAX, MIN, and the current measured values (Fig. C) will be displayed on the screen. The angle will be calculated and displayed
on the screen at the same time. To stop continuous measurement, press (3) or (7).
Area measurement
Press (4) to enter the area measurement mode. Aim the laser beam at the target and press (3) to measure two sides of the
target. The area will be calculated automatically (Fig. D).
Volume measurement
Press (4) to enter the volume measurement mode. Aim the laser at the target and press (3) to measure the length, width, and
height of the three-dimensional target. The volume will be calculated automatically (Fig. E).
Addition and subtraction
Direct the laser beam at the target and then take a measurement. Press (9) to add the next measurement (plus icon appears on
the screen). Take the next measurement. Press (8) to subtract (minus icon appears on the screen).
The addition and subtraction functions are available in Single, Area, and Volume measurement modes.
Calculations with 2 additional measurements (Pythagorean theorem)
Press (4) to enter the calculations with 2 additional measurements (Pythagorean theorem) mode. Aim the laser at the target
and press (3) to measure the lines
Figure C
Figure D
Figure E
and (Fig. F). The L line length will be calculated automatically.
Figure F
7