Storage; Troubleshooting - Silvercrest SFR 3.7 B2 Bedienungsanleitung

–
Fix the blue rod back in place with the
nozzle . Ensure that the sealing rings are
correctly inserted.
–
Replace the dirt container
unit by pushing the front part into the
motor unit and then pushing the rear part
downwards so that the dirt container
clicks firmly into place.
–
Push the vacuum attachment
motor unit .

Troubleshooting

Defect
The appliance is
not working.
Streaks keep
appearing during
cleaning.
The spray bottle
does not work.
If the malfunction cannot be corrected with the above suggestions, or if you have found
some other kind of malfunction, please contact our Customer Service.
■ 8 │ GB │ IE │ NI
on the motor
onto the
Cause
The appliance is not charged.
The appliance is defective.
The blade is dirty.
The blade is worn.
Too much cleaning agent has been added.
There is no water/cleaning agent in the
spray bottle.
The spray bottle is defective.
The tip of the spray bottle is set to OFF.
■ Wipe the charger
that the charger
reconnecting it to the mains.

Storage

■ Store the cleaned appliance in a clean, dust-free
and dry location.
Charge the appliance.
Contact Customer Services.
Clean the blade.
Remove the blade sideways from
the vacuum attachment
Moisten the blade at the round
end with water or detergent, turn
it over and push it back into the
vacuum attachment
Use less cleaning agent.
Refill the spray bottle with water/
cleaning agent.
Contact Customer Services.
Turn the tip to SPRAY or
STREAM.
with a damp cloth. Ensure
is completely dry before
Solution
.
.
SFR 3.7 B2