Autoboil Mode - Panasonic KY-T937VL Bedienungs- Und Installationsanleitung

IH Cooking

Autoboil Mode

Brings a pan of water to the boil.
Available on the left cooking zone only.
1. Select the cooking zone required.
2. Touch
- The appliance beeps 5 times when the water
1 - 9
- After beeping the count-up timer starts
NOTE
Temperature '100' will fl ash in the display until the
boiling temperature is reached. After the water is
100
boiled, the appliance automatically defaults the
temperature to '95'. Increase or decrease the
temperature between '65-100' as required in 5 °C
steps.
3. Turn off the cooking zone. (See page 19)
NOTE
■ The cookware size and material (e.g. non-stick coating) and the
volume of water may affect the sensor detection. If the water has not
boiled after beeping or it has boiled but the appliance does not beep,
select a temperature as required.
■ Cooking Timer
Once the cooking timer has been set, it is not possible to revert to
the count-up timer.
22
EN-
[Autoboil] key.
reaches boiling point and maintains a rolling boil.
After beeping add ingredients and adjust the
temperature with the slider as required.
automatically.
can be used with Autoboil Mode. (See page 29)
IH Cooking
Autoboil Mode is developed for boiling water only.
To achieve the optimum performance, the following is
recommended.
Min. 3 cm
■ Use a lid until boiling.
Min. 0.5 L / 1 L
■ Use a minimum of 0.5 L of water. If a larger pan that
covers 3 or more areas of fl ex cooking zone, use a
minimum of 1 L of water.
■ Minimum 1 cm of depth when fl ex cooking zone is
used.
In order to prevent water boiling over from the pan, the
following is recommended.
■ No more than 70% pan capacity should be used.
■ There should be a minimum gap of 3 cm between
the lid and the water surface.
23
EN-