PowerWalker VI 650SE LCD Schnellstartanleitung Seite 11

6. Functions & Operation
I: DC Start Function
DC Start Function enables UPS to be started up when AC utility power is not available and battery is fully
charged. Just simply press the power switch to turn on the UPS.
II: AVR (Automatic Voltage Regulation)
If the quality of the incoming mains is poor, the AVR boosts a low incoming voltage or reduces a high one. The
load receives a voltage within the normal range.
III: Auto restart while AC recovery
IV: Audio Indicator
Audible Alarm
Sounding every 10 seconds
Sounding every 1 second
Sounding every 0.5 seconds
continuous sounding
7. Software Installation on your PC
Connected by USB to a PC or notebook, the Software enables communication between the UPS and the
computer. The UPS software monitors the status of the UPS, shuts down the system before the UPS is
exhausted and can remotely observe the UPS via the Network (enabling users to manage their system more
effectively). Upon AC failure or UPS battery low, UPS takes all necessary actions without intervention from the
system administrator. In addition to automatic file saving and system shut-down functions, it can also send
warning messages via pager, e-mail etc.
•
Use the bundled CD and follow the on-screen instructions to install the software WinPower.
•
Enter the following serial No. to install software: 511C1-01220-0100-478DF2A
•
After the software is successfully installed, the communication with UPS has been established and a
green icon will appear in the system tray.
•
Double-click the icon to use the monitor software (as above).
•
You can schedule UPS shutdown/start-up and monitor UPS status through PC.
•
Detail instructions please refer to the e-manual in the software.
Check www.powerwalker.com/winpower.html
version of monitoring software.
Situation
Battery Mode
Battery Low
Overload
Faulty
from time to time to get the latest
EN
9