Electrical Connection - IKEA FRAMTID CG7 N Gebrauchsanweisung

ENGLISH

Electrical connection

Before connecting the appliance, make sure
that:
1. the house electrical power supply
nominal voltage matches that of the
appliance, as given on the rating plate;
2. the power supply line to which the
appliance is connected is of adequate
power with respect to the max. power
absorbed by the appliance, as given on
the rating plate;
3. the house electrical system has a correct
grounding system.
• An omnipolar switch with a distance of
at least 3 mm between contacts must be
installed.
NOTE: after installation, the electrical
components must only be accessible with
the use of a special tool.
The power cord must be of the H05RR-F
type, in compliance with the table given
below.
Power supply
voltage
1N ~ 230 V
Number of wires x
dimensions
3 x 1.5 mm
2
Instructions for the installer
• Disconnect the power plug and close the
gas tap before carrying out any repairs
or operation.
• The qualified technician is responsible
for the correct electrical and gas
installation according to current safety
regulations.
• Grounding of the appliance is
mandatory by law.
The Manufacturer declines any responsibility
for possible damage to persons, animals
or things due to non-compliance with the
above mentioned regulations. The technical
data is given on the rating plate located
on the back side of the appliance. The
adjustment conditions are given on a label
applied on the packing. Do not use the oven
door handle grip for handling operations,
or for removing the appliance from the
packing.
This appliance is in Class 1 (free standing
appliance).
123