temperature is high, it may take more than 4 hours for food to cool down completely (try to
open the refrigerator door as rarely as possible).
If the refrigerator is installed in a wet place, be sure to check if the earthed cord and the
leakage breaker are working normally. If vibration noises occur due to contact of the
refrigerator with the wall or if the wall turns black due to air convection around the compressor,
keep the refrigerator further away from the wall. The installation of the refrigerator may cause
noise interference or image problems in mobile phones, landline phones, radio receivers, or
TVs near the appliance, so in this case, keep the latter as far away from these objects as
possible.
Changing the opening direction of the door
If desired, you can change the direction in which the door opens, from the right side (by default)
to the left side.
Warning
-
The refrigerator must not be connected to the power socket when you change the opening
direction of the door. Make sure to disconnect the plug from the power socket.
-
It is advisable that two people change the opening direction of the door.
Fig. 3 key:
1. Hinge cover
2. Screws
3. Top hinge
Fig. 4 key:
1. Refrigerator compartment door
2. Centre hinge
3. Door bushing
4. Screws
Fig. 5 key:
1. Bottom hinge
2. Screws
Fig. 6 key:
1. Pin shaft
2. Pin screw
3. Pin shaft
4. Washer
5. Nut
72
BOLERO COOLMARKET COMBI 322 WD INOX E