Attaching Wireless Lan Card; Setting Card In Pc Card Slot - NEC NP1000 Bedienungshandbuch

4. Attaching Wireless LAN Card

Insert the wireless LAN card into the PC card slot on the rear panel of the projector.
Important
• The wireless LAN card must be inserted into the PC card slot in the correct direction. It
cannot be inserted in the reverse direction. If the card is inserted in the reverse direction
with excessive force applied, the pins in the projector and the PC card slot may break. Be
sure to insert the wireless LAN card with its label facing up.
• Before touching the LAN card, touch a metallic object (such as a door knob or aluminum
window frame) to discharge the static electricity from your body.
• Always insert or remove the wireless LAN card when the main power is turned off. Failure to do
so may cause projector malfunction or damage to the wireless LAN card. If the projector will not
work correctly, turn off the projector, wait 30 seconds, and turn it back on.

■ Setting card in PC card slot

1
Press POWER
the projector to Stand-by mode, press the "O
(off)" side of the main power switch of the
projector.
2
With the label on the wireless LAN card facing
up, slowly insert the card into the slot
horizontally.
Note
Do not apply any excessive force while inserting the card.
ON/STAND BY
button to set
4. Attaching Wireless LAN Card
4
11