Copy One Memory To Another; Exponential Function Steering; Throttle Curve (Th.c) - GM-Racing 94011 Bedienungsanleitung

COPY ONE MEMORY TO ANOTHER:

1. Press "+" or "-" to choose "CPY".
2. Press "ENTER" to enter copy mode, Press "+" or "-"to choose "Mod01....Mod15".
3. Press "ENTER" to save your setting and Press "EXIT"leave CPY interface, and
back to the function menu interface.
6. EXPONENTIAL FUNCTION STEERING (ST.C)
This function is used to change the sensitivity of the steering servo around the neutral positi-
on. It has no effect on the maximum servo travel. Note: When the setting is not determined,
or the characteristics of the model are unknown, start with 0% (when EXP is set to 0%, servo
movement is linear).
1. Press "ENTER" in the power on interface and enter function menu. Press "+" or "-"
to choose "ST.C" and press "ENTER" and enter STEERING adjusting interface.
2. Press "+" or "-" to choose "LINE"or "EXP", Press "ENTER" to choose "L"or
"H", and then press "+" to increase and "-" to decrease the value of the corres-
ponding item.
3. LINE adjusting value range:
(L):0~50 %, default is 0%, (H):50~100 %, default is 100%
4. EXP adjusting value range: -100%~+100 %, default is 0%
5. Press "EXIT"to save your setting and leave STEERING interface, and back to the
function menu interface.

6. THROTTLE CURVE (TH.C)

This function makes the throttle high side and brake side direction servo operation
quicker or milder. It has no effect on the servo maximum operation amount. For the high side,
selection from among three kinds of curves (EXP/VTR/CUR) is also possible.
1. Press "ENTER" in the power on interface and enter function menu. Press "+" or "-"
to choose "TH.C". And press "ENTER" and enter THROTTLE adjusting interface.
2. Press "+" or "-" to choose "LINE"or "EXP", Press "ENTER" to choose "L"or "H"
and then press "+" to increase and "-" to decrease the value of the corresponding item.
3. LINE adjusting value range:
(L):0~50 %, default is 0%, (H):50~100 %, default is 100%
4. EXP adjusting value range: -100%~+100 %, default is 0%.
5. Press "EXIT"to save your setting and leave THROTTLE interface, and back to the
function menu interface.
05 94011 GM-Racing XG-6 Race Spec Instructions
94011-eng.indd Druckbogen 6 von 8 - Seiten (6, 11) 94011-eng.indd Druckbogen 6 von 8 - Seiten (6, 11)
94011 GM-Racing XG-6 Race Spec Instructions 10
03.12.2008 08:16:56 03.12.2008 08:16:56