Scholtes B PMG 41 DCDR Series Bedienungsanleitung Seite 15

Securing the appliance to the cabinet Securing the appliance to the cabinet Securing the appliance to the cabinet
Securing the appliance to the cabinet Securing the appliance to the cabinet
There are three different groups of appliance as far as
installation is concerned:
BUILT-IN HOB
HEIGHT= STEEL THICKNESS
BUILT-IN HOB
STEEL TICKNESS <HEIGHT <58mm
SIT ON - ON HOB
HEIGHT >58mm
Fig.2
1- Built-in hobs to be slotted in (Class 3 - see figure 2,
detail H1). In this case it is necessary to make a
hole in the worktop whose measurements match
those of the hob. The measurement at the side
should be reduced by 2 cm so as to ensure that 1
cm of the perimeter of the hob overlaps with and
rests on top of the supporting surface. To slot in the
hob flush with the worktop, the cut-out on this
supporting surface must be lowered (see figure 3a),
so that both the edge of the hob and the seal under
it can be positioned there. Before fitting the hob to
the worktop, position the seal G provided along the
perimeter of the hob, as illustrated in figure 3b.
Brackets for fixing hobs to the cabinet have been
provided, and these should be fitted as shown in
detail S (fig.3a).
2- Built-in hobs (Class 3) with edges lower than 58 mm
(see figure 2, detail H2)(fig 3c). To install this type of
hob, a hole large enough to accommodate the whole
lower casing of the appliance must be made on the
worktop intended to be under the hob. Remember to
leave a gap of at least 1 cm between the lower
casing and the worktop around the whole perimeter
of the appliance (the underside of the casing can,
however, touch the surface below it). To fit the
appliances, follow the instructions given above in
point 1 or use any supplementary instruction leaflet
that is provided in special cases.
3- Sit-on hobs (Class 1) with edges higher than 58 mm
(see figure 2, detail H3). In this case, the lower
Fig.3a
G
Fig.3b
Fig. 3c
GB
15