Werbung
Verfügbare Sprachen
Verfügbare Sprachen
14.3
Electrical connection
Dangerous electrical voltage!
Risk of injury due to dangerous electrical voltage!
The machine may only be connected to the power supply and the associated
checks carried out by a qualified electrician or under the instruction and
supervision of a qualified electrician!
Check, whether the neutral connection (if existing) and the protective grounding function
properly.
Check, whether the supply voltage and the frequency correspond to the specifications of the
machine.
Deviation of the supply voltage and frequency!
A deviation from the value of the supply voltage of ±5 % is permissible.
A short-circuit fuse must be provided in the power supply system of the machine!
Use a supply cable that fulfils the electrical requirements (e.g. H07RN, H05RN) and take the
required cross-section of the supply cable from a current carrying capacity table. Pay
attention to the measures for protection against mechanical damage.
Make sure that the power supply is protected by a residual current circuit breaker.
Connect the machine only to a properly grounded outlet.
When using an extension cable, make sure that the dimension matches the connected load
of the machine. The connection power can be found in the technical data, the correlation of
cable cross-section and cable lengths can be found in the technical literature or obtain
information from a specialist electrician.
A damaged cable must be replaced immediately.
15
OPERATION
Only operate the machine when it is in a perfect condition. Before each operation, a visual
inspection of the machine must be carried out. Safety devices and operating elements must be
checked carefully. Check screw connections for damage and tight fit.
15.1
Operating instructions
Check the oil level in the compressor pump before commissioning.
The machine should be set up near the working consumer. Avoid long air lines and long
supply lines (extensions).
ZIPPER MASCHINEN GmbH
www.Zipper-Maschinen.at
3. Mount transport handle
Remove the screws from the bore holes (4).
Push the transport handle into the holes and fix it
with the screws (4).
4. Check the oil and top up if necessary
Place the machine on a level surface.
Use the oil sight glass (5) to check whether oil has
been filled up to the center mark. If not, top up the
oil.
Filling with oil
Remove the transport plug from the oil filler
opening (6).
Fill the oil into the oil filler opening (6) up to the
center mark in the oil sight glass (5).
5. Fitting the oil filler plug
Close the opening (6) with the oil filler plug (7).
W A R N I N G
N O T E
OPERATION
25
ZI-COM90-10
Werbung
