Aeco VacuBot X5 PLUS Kurzanleitung Seite 2

VacuBot X5 PLUS
Quick start guide
Preparation
1.
Set up the base station as shown in the
illustration and connect it to the power supply.
61
cm
First steps
1.
Remove the protective
devices from the robot.
2.
Fit the side brush:
Press the side brush down
firmly until you feel it click into
place to attach it to the robot.
Connect & set up
1.
For the initial installation, please
press both buttons simultaneously
for 5 seconds until you hear a
voice prompt and the WiFi
symbol flashes.
2.
Open the AX Home app and tap
+
on the „ " symbol at the top
right and then on
„Add device".
3.
Once the device has been
recognized, it is displayed
at the top. Tap on "Add"
to the right of it.
IMPORTANT:
Depending on local conditions, it may take some time to create the map.
Please allow the device to fully charge again afterwards.
61
cm
152
cm
5
Sek.
Add device
Device recognition running...
Add
2.
Ensure that the sweeping area is
free of obstacles during mapping.
3.
Place the device on the charging
station to switch it on and charge it.
Check that the contacts are touching
securely. The device starts and begins
the charging process. Once this is
complete, Power and the Home
button light up green constantly.
4.
Scan the QR code and
download the AX Home app.
Open the app and log in with
your user data or create a
new account.
4.
If necessary, select your Wi-Fi
in the next step and enter the
password.
If required, then switch back
to the app.
5.
Tap on „Complete" and then on the device name to continue
with the setup. Follow the instructions in the app.
6.
Charging:
Place the robot in its
place and fully charge it
7.
Once the charging process is
complete, Power & Home button
light up green constantly.
Now open the app and let your device create a map.
If the installation was not successful, check whether the 5GHz network is
activated in your router. If this is the case, you must separate the networks
by name."Router1 " and 'Router2' is sufficient in this case, for example.
Then connect the device to the router on which you have only activated
the 2.4 GHz network.
3.
Please note that all doors to the areas
to be mapped or cleaned should be
open.
Enter Wi-Fi
Information
Wi-Fi network
Password