Werbung
Verfügbare Sprachen
Verfügbare Sprachen
9. CLEANING AND MAINTENANCE
In order to maintain health standards and good beverage quality, the tanks, lids and mixing paddles/pumps should be
cleaned as often as possible.
NOTE: Do not clean the machine with a stream of water.
1. Disconnect the device from the power source before cleaning.
2. Completely empty the tanks.
3. Remove the agitator, lift the plastic tank and disconnect it from the cooling element.
4. Clean the tank with warm water and mild dishwashing liquid.
5. After cleaning, wipe the tanks dry.
6. Remove the gasket from the cooling element and wipe with a damp cloth. Place the gasket in the base of the tank.
Clean the cooling element with a damp cloth and apply the tank.
CAUTION: Do not use solvents (gasoline, alcohol, etc.) to clean the device. The housing of the device may be damaged
and explosive fumes may be produced. Pay special attention when applying the gasket. Incorrect placement of the ga-
sket may cause leaks. Do not use abrasive or corrosive agents to clean the device.
The device can be cleaned with a damp towel, but never immerse it in water. After cleaning the device, make sure it is
completely dried.
10. PROBLEMS, CAUSES, SOLUTIONS
Problem
Possible causes
No power to
Main switch is not on the "I" position.
machine
Gas leak into the cooling circuit.
Machine is not
cooling
Compressor protector is broken
Compressor
does not start
Compressor motor is broken
Gas leak into the cooling circuit
One tank is not
cooling
Tube of the cooling circuit is clogged.
The mixing padd-
les are
not working
Plug is not in.
Power cord is broken.
Main switch is broken.
Compressor does not start
Condenser is clogged.
Fan motor is burnt.
Lack of air flow
Main switch is broken
Compressor relay is broken
Condenser is clogged
Lack of air flow
Filter is clogged
The mixing motor is broken
Solution
Insert plug into mains socket
Switch main switch to "I" position.
Replace power cord
Replace main switch
See "compressor does not start"
section.
Find leak, filter it out and re-charge
the cooling circuit
Clean the condenser
Replace fan motor
Increase distance between the
machine and other obstacles /
heating sources
Replace main switch
Replace compressor protector
Replace compressor relay
Replace motor
Find leak, filter it out and re-charge
the cooling circuit
Clean the condenser
Increase distance between the
machine and other obstacles /
heating sources
Cut the tube, eliminate clog, re-
-charge the cooling circuit
Replace the filter
Replace the mixing motor
- 17 -
Ask for authorized
service department to
check and repair it.
Ask for authorized
service department to
check and repair it.
Werbung
