Electrical Connections; The First Wash Cycle; Technical Data; Water Connection - Indesit IWB 61051 Bedienungsanleitung

Connecting the drain hose
! We advise against the use of hose exten-
sions; if it is absolutely necessary, the exten-
sion must have the same diameter as the
original hose and must not exceed 150 cm in
length.

Electrical connections

Before plugging the appliance into the electri-
city socket, make sure that:
• the socket is earthed and complies with all
applicable laws;
• the socket is able to withstand the maximum
power load of the appliance as indicated in
the Technical data table (see opposite);
• the power supply voltage falls within the
values indicated in the Technical data table
(see opposite);
• the socket is compatible with the plug of
the washing machine. If this is not the case,
replace the socket or the plug.
! The washing machine must not be installed
outdoors, even in covered areas. It is extreme-
ly dangerous to leave the appliance exposed
to rain, storms and other weather conditions.
! When the washing machine has been instal-
led, the electricity socket must be within easy
reach.
Connect the drain
hose, without bending
it, to a drainage duct
or a wall drain located
at a height between
65 and 100 cm from
the floor;
alternatively, rest it on
the side of a washba-
sin or bathtub, faste-
ning the duct sup-
plied to the tap (see
figure). The free end
of the hose should
not be underwater.
! Do not use extension cords or multiple sockets.
! The cable should not be bent or compressed.
! The power supply cable must only be repla-
ced by authorised technicians.
Warning! The company shall not be held
responsible in the event that these regulations
are not respected.

The first wash cycle

Once the appliance has been installed, and
before you use it for the first time, run a wash
cycle with detergent and no laundry, using the
wash cycle 2.

Technical data

Model IWB 61051
width 59.5 cm
Dimensions height 85 cm
depth 51,7 cm
Capacity from 1 to 6 kg
please refer to the technical
Electrical
data plate fixed to the ma-
connections
chine
maximum pressure 1 MPa
(10 bar)
Water con-
minimum pressure 0.05
nection
MPa (0.5 bar)
drum capacity 46 litres
up to 1000 rotations per
Spin speed
minute
Test wash
cycles in
accordan- Programme 2: Cotton stan-
ce with dard 60°C;
regulation Programme 3: Cotton stan-
1061/2010 dard 40°C.
and
1015/2010
This appliance conforms to
the following EC Directives:
- 2004/108/EC (Electroma-
gnetic Compatibility)
- 2012/19/EU (WEEE)
- 2006/95/EC Low Voltage)
GB
3