styling with the attachment for creating volume in layered
styles
1
Take a section that is 2-3cm wide. If you have a layered style, make
sure the section consists of hair of the same length and layer.
Place the hair between the plates in such a way that the tip of the
attachment is close to the hair roots.
Make sure you do not touch your scalp with the tip of the attachment
to prevent burning your skin.
Press the handles of the appliance firmly together.
Slide the styler gently down the length of the hair in a few seconds,
from root to hair end, without stopping to prevent overheating.
5
Repeat this process after 0 seconds until you have achieved the
desired look.
6
Let your hair to cool down. Do not comb or brush it before it has
cooled down, as this would ruin the hairstyle you have just created.
changing the attachments
1
Switch off the appliance.
Wait until the appliance has slightly cooled down.
Press the release button at the top of each handle (Fig. 6).
Note: You have to release both attachment parts separately
Grasp the cool grip area with two fingers and gently pull the
attachment parts out of the handles.
The attachment parts can still be hot. Always make sure you put them
on a heat-resistant surface.
5
Insert the parts of the attachment you want to use into the handles
and push them home ('click').
EnglisH
11