Samsung DW60H9970U Series Benutzerhandbuch Seite 31

PROBLEM
Has food particles
remaining on the
dishes.
Does not dry dishes
well.
Is too noisy.
Leaves a yellow or
brown fi lm on cups or
dishes
Does not have any
indicators lit.
Does not have
smoothly rotating
arms.
Leaves a white
coating on cutlery
or crockery after
cleaning.
User Manual_DW9000H-Series-00156A-03_EN_150112.indd 31 User Manual_DW9000H-Series-00156A-03_EN_150112.indd 31
POSSIBLE CAUSE
An inappropriate programme
was been selected.
The fi lter is contaminated or not
correctly fasten.
No dishwasher detergent or not
enough detergent is being used.
The pressure of the supplied
water is low.
Spray arm jets are clogged.
The dishes are improperly
loaded.
The water is too hard.
There is no rinse aid in the
dispenser or not enough rinse
aid was used.
Multi taps were used without
selecting the Dry+ function.
Glasses and cups with concave
bottoms hold water. This water
may spill onto other items when
you are unloading.
The dishwasher beeps when the
dispenser cover is opened and
during the initial stage of draining
the pump operation.
The dishwasher is not level.
There is a 'chopping' sound
because an arm is bumping
against the dishes.
This can occurs from coff ee and
tea soils.
The power cord is not
connected.
The arms are clogged with food
particles.
Hard water was used.
English - 31
SOLUTION
Select a programme according to the soil level
of the dishes as directed in this manual.
Clean the fi lter and make sure the fi lters are
fi tted properly.
Use an automatic dishwasher detergent or
use more detergent.
The water supply pressure must be between
0.05 MPa and 0.8 MPa.
Clean the spray arms.
Rearrange the dishes so they have good
water access and do not interfere with spray
arm and dispenser operation.
Check salt refi ll indicator and refi ll dishwasher
salt.
Check the dispenser and add rinse aid.
Check rinse aid setting.
Select the Dry+ function or use rinse aid.
After fi nishing the cycle, empty the lower rack
fi rst and then the upper, this will avoid water
dripping from the upper rack onto the dishes
in the lower rack.
This is a normal operation.
Ensure that the dishwasher is level.
Rearrange the dishes.
Use programme with higher temperature.
Connect the power cord.
Clean the arms.
Check the salt fi ll indicator and softener
setting is correct according to the water
hardness of your area.
Check salt reservoir cap is correctly fi tted.
2015-01-12 2015-01-12 2:38:44 2:38:44