Würth 0864 20 Originalbetriebsanleitung Seite 16

Surface ma- Penetration
terial depths
Concrete 22 - 30 mm
Steel 4 - 12 mm
Full brick 25 - 40 mm
Minimum distances of the axles and
distances to the surface edge
The distance to free edges must be sufficient to
prevent the pin from lateral penetration.
Do not drive in the pins too close in order to prevent
them from comming loose from their fixing position
in case the material breakes out or tears away.
Brickwork
Minimum axle 35 mm
distance
Minimum 150 mm
distance to
edges
Selection of driving pin
Use only Würth driving pins (see accessories) for
this device.
Since fastening material undergoes continuous
development, it is possible that not all admissible
driving pins are listed. For this purpose contact your
Würth customer service or use the latest catalogue.
Infinitely variable performance
control
Before taking the device into service adjust
■
performance control to "–".
To increase or to reduce the thrust performance,
■
turn the adjustment screw to "+" or "–".
To check the adjustment look at the performance
■
scale.
Adhere to the operating instructions.
Minimum
strength
100 mm
100 mm
100 mm
Concrete Ferro- Stahl
concrete
75 mm 25 mm
75 mm 12 mm
Prior to operation (fig. I)
Fit the spall guard [2].
■
Press the device unloaded against a suitabale
■
surface.
Actuate the trigger [4].
■
You should hear an audible "click"!
■
Release the pressure on the device.
■
Operation (fig. I)
Danger
Do not aim the tool at others.
Warning
We recommend to operate the device
only with spall guard [2].
Warning
Check the device daily for correct
functioning before you start working
and inspect it visually. The device may
not be used if any technical or visible
defect has been detected.
Insert the cartridge strip into the cartridge
■
guide [5].
Select the fastening pin and slide it completely
■
in the muzzle [1].
Hold the device with both hands and stand in a
■
stable position.
Set the device vertically on the surface and
■
press on firmly.
Actuate the trigger [4].
■
Warning
Immediately stop working if you detect
any visible defects on the device
(cracks or other damage) and replace
the defective part or send it to Würth to
have it repaired.
Unloading the device
WARNING
Always remove the cartridges first
when unloading the device!
17