Installation And Setting; Operation - MEISTER CRAFT MWS 2400 Betriebsanleitung

5455380-Winkelschl-man 30.01.14 07:10 Seite 37
7 – Installation and setting
Disk guard
The scope of the delivery for this power
tool contains a protective hood for
cutting discs (3) and one for roughing
discs (15).
The position of the disc covers (3/15)
can be adapted to suit the relevant
working conditions. To do this, loosen
the screw (12) with a screwdriver and
turn the cover to the new position.
Tighten the screw back up again (fig. 3).
CAUTION! The closed part of the
disk guard should always point
towards the user to protect him from
sparks and chippings.
Mounting and removing the disc
cover
If necessary, and if the situation requires it,
the disc cover can be exchanged. To do
this, loosen the screw (12) in such a way
that the cover can be removed by turning
it out of the guide groove of the sanding
head.
Mount in reverse order.
Additional grip
Depending on the working method, the
additional handle (2) can be mounted in
three different positions on the grinding
head (fig. 4).
Mounting tools
CAUTION! Before working on the
machine, always pull out the
power plug!
Cutting and roughing disks
All types of grinding and cutting disks
(elbowed A/B, flat, and 'diamond' C) can
be mounted on the spindle (6) (fig. 2).
Depending on type and thickness of the
disk, always select a suitable arrangement
of clamping disk (7) and nut (8).
Press the spindle-locking button (4)
in deep and hold it in this position.
If necessary, turn the spindle
slightly with the free hand until it locks
into position. Tighten the clamping nut
with the flange key provided (fig. 5). Do
not work with disks thicker than 6 mm.
CAUTION! Allow disks to cool
down before changing them.
HOT! Always work with the disk guard
in position!
CAUTION! With accessories,
always comply with the
manufacturer's directions. The
maximum rotation speed must be
greater than the idling speed of the
machine.
8 – Operation
Switching on (fig. 7)
Grasp and hold the machine firmly by
the handle (9) and additional handle (2).
Push the safety slide switch (1a) in
arrow direction with the index finger and
press the On/Off switch (1b) in arrow
direction with the whole hand (fig. 7).
Soft start
The tool has an electronic soft-start
system to start-up the motor gently. The
maximum speed required for working is
reached within a matter of seconds.
37