Setting The Display Brightness; Cleaning And Maintenance - Philips HF3485 Bedienungsanleitung

1 Switch on the lamp and/or the radio or music from a USB stick. See sections 'Using the
appliance as a bedside lamp' and/or 'Using the radio/playing music from a USB stick' in
this chapter.
2 Follow the steps in section 'Menu functions' in this chapter to select the sunset simulation
function and to set the sunset simulation time.
You can choose a time from 15 to 90 minutes (15, 30, 60 or 90).
,
Note: After the set time, no matter whether only the light and/or the radio are on, the sunset simulation
switches off both light and sound.
Tip: You can also press the light on/off button for 3 seconds to activate the sunset simulation
function (Fig. 33).
using the appliance as a bedside lamp
You can use the appliance as a bedside lamp.
1 To switch on the lamp, press the lamp on/off button. (Fig. 14)
Note: It takes approx. 1 second for the lamp to go on. This is normal, the lamp needs to heat up.
2 Press the light intensity increase and decrease buttons to select a light intensity (Fig. 15).
You can choose a light intensity between 1 and 20.
Note: The light intensity you have selected is automatically set as the light intensity level for the alarm
as well.
3 To switch off the lamp, press the lamp on/off button again.

setting the display brightness

1 Follow the steps in section 'Menu functions' in this chapter to select the display brightness
function and to set the desired display brightness. (Fig. 34)
You can select a display brightness between 1 and 4.
,
Tip: If you set the display brightness to level 1, the appliance consumes the least power.
Note: The display brightness automatically increases to maximum level when setting the appliance to
allow the user optimal visibility. When the user has finished setting the appliance and leaves the menu,
the display brightness automatically returns to the set level.

cleaning and maintenance

Never use scouring pads, abrasive cleaning agents or aggressive liquids such as petrol or acetone
to clean the appliance.
Regularly remove dust from the outside of the appliance with a dry cloth.
1 Unplug the appliance before you clean it.
2 Clean the outside of the appliance with a dry cloth.
Do not let water run into the appliance or spill water onto the appliance (Fig. 3).
replacement
Except for the lamp, the appliance does not contain any serviceable parts.
The lamp has to be replaced when it stops burning or when the light output decreases (also see
chapter 'Important'). You must replace the lamp with a Philips Halogen lamp, 100W, 12V, GY6.35.
Only this lamp provides the correct light intensity.
Note: This appliance has been designed to be used with self-shielded lamps only (Fig. 35).
EnglisH
13