Werbung
Verfügbare Sprachen
Verfügbare Sprachen
12
3
Programming mode
3.2.9 Flash time
Function
Flash time
The flash time can be changed according to line requirements, in
increments of 10 ms.
Factory setting: 20, which is equal to 200 ms
3.2.10 CLIP
Function
CLIP
Evaluation of number presentation (CLIP) is deactivated.
CLIP
Evaluation of number presentation (CLIP) is activated. The number
transferred is sent to the called handset.
Factory setting: 1
3.2.11 Changing the PIN
Function
Changing the PIN
Access to programming mode can be protected using the four-digit PIN.
The PIN only needs to be entered if a new PIN has been set beforehand
in programming mode. To change the PIN, activate programming mode,
enter the new PIN twice and confirm this by pressing
confirmed by the positive acknowledgement tone. Programming mode
can then only be accessed again by entering the new PIN once more. To
restore the factory setting, change the PIN to 0000.
Parameter
Inputs
code
23
0...255 #
Parameter
Inputs
code
24
0 #
24
1 #
Parameter
Inputs
code
26
new PIN new PIN #
#
. The change is
3
Programming mode
If you forget the PIN, the distybase duo/duo exant can only be reset by
the Customer Service department.
Factory setting: 0 0 0 0
3.2.12 Music on hold
Function
Parameter
code
MOH
27
An external caller on hold hears no call on hold tone.
MOH
27
An external caller on hold hears call on hold tone.
Factory setting: 1
3.2.13 Blacklist
Function
Parameter
code
Blacklist
40
The subscriber is not monitored by the blacklist.
Blacklist
40
The subscriber is monitored by the blacklist.
Factory setting: 0
Function
Parameter
code
Exclusion area
41
Entry is stored.
13
Inputs
0 #
1 #
Mob. no. Inputs
1...8
0 #
1...8
1 #
Entry
Inputs
no.
1...5
No.
max. 6
figures #
Werbung
