Preliminary Check; Hot Water - Sanremo Milano LX SAP Bedienungsanleitung

ENGLISH
USE

Preliminary check

Before using the appliance, check that:
- the plug is inserted properly into the mains power outlet;
- the filling hose is correctly connected to the mains outlet and that the water supply is open. Also
check for leaks;
- the drain hose is positioned according to the above instructions and fixed by a hose clamp.
With the steam tap (B) open, put the on/off switch (D) to position 1 and wait for the water in the boiler
to reach the maximum level set by the electronic control, which can be visually checked on the
level indicator (L). If the boiler does not fill within the set time-out (90 sec.), the pump stops and the
indicator lights on the control panel start to blink. If this happens, put the on/off switch (D) to position
0 and then to position 1 per to complete filling of the boiler.
Than put the on/off switch (D) to position 2, which switches on the electric heating elements to start
heating the water.
Wait for steam to come out the steam nozzle (B), then close the tap and, using the Boiler pressure
gauge, check that the pressure has reached and maintains a value of 0.8:1 bar. If not, use a
screwdriver to turn the pressure switch adjustment screw towards + or - as shown below.
N.B. Manual filling
Even if the control unit fails to operate, the appliance boiler (A) may be filled manually.
With the visual help of the level indicator (L), keep the manual filling knob (A) pressed until the water
fills the boiler, taking care not to exceed the maximum indicator level (L); then release the knob. In
this circumstance, use the manual switch (R) to dispense coffee.

Hot water

Check through the water level indicator (L) that there is sufficient water in the boiler before dispensing
hot water or steam.
Ensure that the boiler pressure gauge indicates a pressure of 0.5:1 bar.
Press the button (M6) to dispense hot water and press again to stop.
Pay the utmost attention in order to prevent scald burns.
Steam
Except for the 1-group machine that has just one steam nozzle, all the other models have 2 located
at the sides. These steam nozzles are recessed but can swivel out thanks to an articulated joint. To
dispense steam, just turn the knobs (B) counter-clockwise.
Pay the utmost attention in order to prevent scald burns.
Coffee with Mod. MILANO LX SAP
Insert the filter holder (E) into the group head (F) turning the filter holder counter-clockwise. Press
the button (I) and wait for the required quantity of coffee to be dispensed, then put it back to its
original position.
37