Menu Overview - testo 176 Bedienungsanleitung

6 Using the product
6.3.
info@Testo-Direct.com
50

Menu overview

The menu overview shows exemplary display
representations of the data logger testo 176 T2.
The data loggers testo 176 T1, testo 176 T3, testo 176 H2
have no display.
The display must be switched on to be able to show the
corresponding indications. This takes place via the testo
Comfort Software.
The indication in the display is updated according to the
programmed measurement rate. Only readings from active
channels are displayed.
The channels are also activated via the testo Comfort
Software.
The symbols for upper or lower alarm value light up in
operating states Rec and End, if the programmed alarm
value has been exceeded or fallen short off.
After 10 seconds without operating a key the display will
return to its initial state.
www.
Testo-Direct
1.888.475.5235
.com