Pioneer PL-6 Bedienungsanleitung Seite 11

SPECIFICATIONS
Motor and Turntable
Drive System ...................04. Direct-drive
Motor. 3 acne aed OU Quartz PLL Hall motor
Turntable Platter ........... 310mm diam, aluminum
alloy die-cast
Speeds 5. x oe) sea eise ened e aokewes ee whoa 33-1/3 and 45rpm
Wow and Flutter ......... Less than 0.025% (WRMS)
Signal-to-Noise Ratio........ More than 78dB (DIN-B)
(with Pioneer catridge model PC-3MC)
Tonearm
TYRE: ees ea eos Static-balance type, Straight pipe arm
Effective Arm Length ................00. 221mm
Overhang: 2.02.03 348 35 eae ewe tot aes 15.5mm
Usable Cartridge Weight ........ 3g (min.) to 8g (max.)
Subfunctions
Auto-return mechanism, Anti-skating force control, Stylus
pressure direct-readout counterweight, Cueing device,
Strobe light, Free stop hinges
Condensation
When this turntable is brought into a warm room from
previously cold surroundings or when the room tem-
perature rises sharply, condensation may form inside
and the unit may not do full justice to its performance.
In cases like this, allow the unit to stand for about an
hour or raise the room temperature gradually.
Miscellaneous
Power Requirements ...... AC220 — 240V ~, 50, 60 Hz
Power Consumption .................0 004 12W
Dimensions .......... 420(W) x 108(H) x 367(D)mm
16-1/2(W) x 4-1/4(H) x 14-7/16(D) in.
Wight: x2 oc Soe 88s. ok a Soe ote ets 5.8kg/12 Ib 13 oz.
PC-3MC Specifications
PY D@e, eve toe eh Se Sepa ats, Se ee AG eased Moving coil type
Stylusiit as 208 3 oe eS ies 0.5 mil diamond (PN-3MC)
Output Voltage ... 2.0... 0.0.0.0... eee 2.5mV
(1kHz, 50mm/s Peak velocity, LAT)
Tracking Force............. 1.7g to 2.3g (proper 2g)
Frequency Response ............... 10 to 32.000Hz
Recommended Load .................200. 50kQ
WeIGKE ones sie eat eae? aise Sa eds Sadie AS a wd 3.1g
Accessories
EP: Adapter'. 25. .0!e 0 hua dd ceded Sosa Ged BES 1
Operating Instructions... 2.2.0.0... ... 0.000 eee 1
NOTE:
Specifications and design subject to possible modification
without notice, due to impromements.
Cartridge replacement
@ Any cartridge besides that supplied having a weight of
between 3 and 8 g may be used with this turntable.
@ The polarities of the accessory headshell's leads are
as shown below. Align them properly.
Red: Right channel (R)
Green: Right channel ground (RG)
White: Left channel (L)
Blue: Left channel ground (LG)
@ The overhang of the tonearm is 15.5 mm.
When using the accessory headshell, the overhang
can be adjusted when the stylus and connector
dimensions are set to 56 mm.
(Unacceptable mounting)
Cartridge is bent
(Acceptable mounting)
Must be mounted in parallel
After having replaced the cartridge, refer to page
5 and perferm the tracking force and antiskating
adjustments again.
11