Activation And Deactivation; Using The Selection Buttons; First Start; Water Circuit Priming - Gaggia Anima Bedienungsanleitung

5.

Activation and deactivation

5.1

Using the selection buttons

5.2

First start

5.2.1

Water circuit priming

5.2.2

Automatic rinse/self-cleaning cycle

5.2.3

Manual rinse cycle

6
ENGLISH
Make sure to read the "3. Safety" chapter.
Some function buttons can be used to navigate through functions / menus:
The OK button is used to select / confirm / stop the function.
The ESC button is used to return to the main menu, one level at a time.
The UP button is used to move upwards.
The DOWN button is used to move downwards.
Before first use the following operations must be carried out:
• Water circuit priming.
• One automatic rinse/self-cleaning cycle.
• One manual rinse cycle.
During this process fresh water flows through the internal circuit and the machine
heats up. The process requires a few minutes.
> Check that the classic milk frother is installed.
Place a container under the milk frother.
>
> Press the OK button to start the water circuit priming cycle. The machine starts
dispensing hot water through the milk frother. The progress bar on the display shows
the status of the operation. The machine automatically stops dispensing water at the
end of the process. The display shows that the machine is heating. At the end of the
heating phase, the machine launches an automatic clean water rinse/self-cleaning cycle
of the internal circuits.
> Place a container under the coffee dispensing spout.
Burning hazard! Be careful of hot water or steam sprays.
The operation lasts less than a minute. Wait for the cycle to end automatically.
If necessary, the cycle can be interrupted by pressing the OK button.
> Empty the container. The machine goes back to the main menu.
Now it is possible to launch the manual rinse cycle.
The complete manual rinse cycle comprises two consecutive phases:
• One "Coffee brewing circuit rinsing phase", to be repeated twice.
• One "Hot water dispensing circuit rinsing phase".
Coffee brewing circuit rinsing phase
During this phase, the coffee brewing cycle is started.
> Place a container under the coffee dispensing spout.
Press the ESPRESSO LUNGO button. The machine starts brewing coffee.
>
Repeat the previous operations, then proceed.
> After the product has been brewed, empty the container.
If necessary, the cycle can be interrupted by pressing the OK button.
Hot water circuit rinsing phase
Follow the instructions in the "4.2 Water tank filling" chapter and fill the water tank up
>
to the CALC CLEAN level.